Cisco WAP321 Wireless-N Selectable-Band Access Point with Single Point Setup - Easy to Install - Enterprise Wi-Fi

RAM installed (max) 64 MB Flash memory installed (max) 16 MB Form factor ABS material Connectivity technology Wireless N Data transfer rate 300 Mbps Data link protocol IEEE 802.11a/b/g/n DFS support No Spread spectrum method OFDM Remote management protocol SNMPv3, HTTP, HTTPS Network and transport protocol DHCP, Bonjour Number of Radios 1 Frequency band 2.4 GHz or 5 GHz MIMO 2 x 3:2 Maximum active WLAN clients 32 Number of access points supported per cluster 8 Status Indicators Power, WLAN, LAN Features DHCP support, load balancing, VLAN support, syslog support, email alert, IPv6, Wireless Distribution System (WDS), firmware upgradable, wall mountable, Spanning Tree Protocol (STP), Wi-Fi Multimedia (WMM), access control list (ACL), quality of service (QoS), RADIUS, Wi-Fi Protected Setup (WPS), multiple SSID, wireless bridge mode, Wireless Scheduler, IPv4,rogue access point detection, captive portal, Single Point Setup Roaming 802.11r (when supported by driver) Encryption algorithm WPA Personal, WPA Enterprise Authentication method RADIUS, Radio Service Set ID (SSID) Compliant standards IEEE 802.3, IEEE 802.3u, IEEE 802.1Q, IEEE 802.11a/b/d/e/g/i/n, IEEE 802.3af, IEEE 802.3az, IEEE 802.1X, Wi-Fi Protected Setup Antenna 3 x internal PIFA Gain level 2 dBi Interfaces 1 Ethernet 10BASE-T/100BASE-TX/1000BASE-T; RJ-45 Miscellaneous Cables included 1 network cable Mounting kit Included Compliant standards FCC Class B certified, IC Power over Ethernet (PoE) supported 802.3af Power adapter - external (not included) Voltage required DC 12V/1A OS provided Linux Mean time between failure (MTBF) 68,248 hours Manufacturer warranty Limited lifetime warranty